steel mill的例句大全

Big Stev sent invitations to everyone in the steel mill towns up and down the valley.

大史蒂夫向遍布山谷的炼钢城镇里的全体工人发了请贴.

Here we are in the yard of the steel mill.

这儿就是不锈钢厂的料场.

Steel mill capacity utilization close to 75 %, not sure when to full capacity.

钢厂产能利用率接近75%, 不能确定何时能够满负荷生产.

Every night you could hear the whistles of the steel mill.

每晚你都会听见炼钢厂的下班哨声。

The steel mill contracted for ten million tons of iron ore.

炼钢厂立约订购1000万吨铁矿.

In the introduction, the meaning of researching the developmental strategies Steel Mill of Tisco is showed.

首先在前言部分说明了研究太钢型材厂发展战略的现实意义.

Typically, a steel mill will choose a particular ore or blend to suit its configuration.

一般来说, 一家炼钢厂会选择适合其设备的某种特定矿石或混合矿石.

In the steel mill, hot rolling is a very main phase.

钢铁行业中, 热轧是非常主要的一环.

Min 3 years in technical position in equipment department of Steel Mill or other heavy industries.

至少3年钢铁企业或其他重工业行业设备技术工作经验.

He is in charge of the operation of the steel mill.

他负责这家钢厂的经营工作.

It is mainly used in lining of lime rotary kiln steel mill, the top of furnace.

主要应用冶金石灰回转窑窑衬 、 平炉炉顶等.

At Shijingshan we passed the huge steel mill and the power plant.

我们还经过了石景山的大钢铁厂和发电厂.

The 3 # TRT of Tangshan steel Mill went into operation in 2000.

唐钢3 # rt煤气余压发电机2000年投产.

The workers in the steel mill have heavy duty golves for handling hot steel.

钢厂的工人们有操作热钢用的耐用手套.

In this paper, the failure form of work roll bearing chock of2050mm hot strip mill in bao steel is studied using Finite Element Method ( FEM) the internal heat resources of bearing system is analyzed.

本文以宝钢2050热连轧机工作辊轴承座热变形故障为研究对象，详细分析了轴承系统的内热源，确认轴承内部的摩擦热是轴承升温的主要热源。

Therefore, The applications of this low-alloy bainite cast steel to ore crusher and ore mill can remarkably increase the operational efficiency of these equipments and decrease the processing cost of ore powder.

因此，这种低合金铸钢应用于矿山行业，可明显提高破磨设备运转率，降低矿粉加工成本。

The phenomenon of longitudinal fission seldom occurred during the process of tube plug drawing mill compared with empty-sunken steel tube. The problem which seldom cause transverse fissure in form of partial failure owing to uniform distribution of axial stress in cross section.

与空拔相比较，在短芯棒拔制过程中，纵裂现象一般不会发生，由于钢管轴向应力在横截面上分布均匀，一般也不会出现以局部破坏形式出现的横裂现象。

The Research of the New Material BGS Steel Used for the Cold Rolling Mill Rollers

冷轧辊新材质BGS钢的研究

Three kinds of main transmission shafts have been used in the cold-rolled factory of Wuhan Iron& Steel ( Group) Corporation since 1700 five-sequential rolling mill was put into operation.

武汉钢铁（集团）公司冷轧厂1700五连轧机及整机自投产以来，使用了3种形式的主传动轴。

I'd rather work in a steel mill and sing Bruce Springsteen songs."

我宁愿留在炼钢厂边工作边哼歌“